Description Of Numeric Readouts - Eagle Tree Systems Vector User Manual

10 Description of Numeric Readouts

The following numeric readouts can be configured for display. Some require optional hardware.
Numeric Readout Name
Main Pack Voltage
Transmitter Voltage
Camera Voltage
Receiver Voltage
Sensor Temperature
Ambient Temperature
Barometric Altitude
Pitot Airspeed
RPM
Main Pack Current
Main Pack Wattage
Prop RPM (Headspeed)
Main Pack mAH Used
Mode Rx Input %
Gain Rx Input %
Aileron Rx Input %
Elevator Rx Input %
Throttle Rx Input %
Rudder Rx Input %
Submode Rx Input %
Kill Switch Rx In %
2nd Aileron Rx In %
2nd Elevator Rx In %
Voltage of the pack connected to the current sensor
Voltage at the "Vid Tx" power connection of the video harness
Voltage at the "Cam/Mic" power connection of the video harness
Voltage at the Vector's servo outputs
Temperature of the optional temperature sensor
Approximate air temperature, obtained from the GPS/MAG sensor
Zero referenced altitude, from the onboard pressure sensor
Airspeed from the optional pitot airspeed sensor
RPM reading from the optional RPM sensor
Current flowing through the current sensor
Voltage X Current at the current sensor
Same as RPM reading above
The milliamp hours through the current sensor since bootup
The measured pulsewidth at the Vector's mode switch input (0% = 1 millisecond,
100% = 2 milliseconds)
The measured pulsewidth at the Vector's gain knob input, if used
The measured pulsewidth at the Vector's aileron input
The measured pulsewidth at the Vector's elevator input
The measured pulsewidth at the Vector's throttle input
The measured pulsewidth at the Vector's rudder input
The measured pulsewidth at the Vector's submode switch input, if used
The measured pulsewidth at the Vector's kill switch input, if used
The measured pulsewidth at the Vector's 2
The measured pulsewidth at the Vector's 2
Description
Aileron input, if used
nd
Elevator input, if used
nd
USER GUIDE
94