Eagle Tree Systems Vector User Manual page 91

External bus error!
Flight Battery Not Detected
Flip crash detected! Disarmed
Flyaway detected-Disarming!
Freefall detected!!!
Gain Knob used but undetected
GPS Status: Awaiting first fix
GPS Status: Awaiting 3D fix
GPS Status: Awaiting Enough Sats
GPS Status: Awaiting HDOP
Accuracy
GPS Status: Post-Fix Countdown
GPS Not Connected!
GPS Fix Lost!
GPS/Compass has old Firmware!
Gyro not detected!
Home Waypoint too far away!
Idle throttle being reduced!
Impact Detected!
Kill Switch Activated!!
Landing - Poor GPS or Mag
Lipo cell count incorrect?
Logging Buffer is Full
This message indicates there was an issue communicating with either
the GPS/MAG, or the pitot speed sensor. If this happens repeatedly, a
cable is loose or damaged, or there's a power or sensor problem.
The low battery autoland feature has detected that no battery is
connected.
If the Vector detects that the multirotor has flipped over after a crash, it
will disarm the motors to try to avoid burning them out.
The Vector has detected an uncontrollable flyaway condition due to
miswiring or bad configuration, and is disarming the motors to avoid
loss of the multirotor.
This is an informational message that will display if the Vector detects a
freefall. This would normally only occur if total loss of motor power or
thrust has occurred, or if the multirotor has been disarmed during flight.
This message will appear if you configured the gain knob, but the
Vector's gain receiver input is not detecting a signal during boot.
Indicates that the Vector is waiting for the GPS to acquire a fix.
Indicates that the Vector is waiting for the GPS to acquire a 3D fix. See
GPS Configuration menu.
Indicates that the Vector is waiting for the GPS to acquire enough
satellites. See GPS Configuration menu.
Indicates that the Vector is waiting for the GPS to have a low enough
HDOP (Horizontal Dilution of Precision). See GPS Configuration menu.
Indicates that the Vector is waiting for the amount of time specified after
the GPS fix is finalized, in the GPS Configuration menu.
The Vector has detected that the GPS is not connected. Check cabling.
This indicates that the GPS has lost its position fix. All GPS modes,
including RTH, will be disabled until it regains a fix.
This message indicates that the firmware on the GPS/MAG needs to be
updated. GPS/Mag firmware updates automatically occur when you
update the Vector firmware, as long as you have the GPS/MAG
connected to the Vector at the same time.
If you repeatedly see this message, DON'T FLY and contact support.
You set up a Home Waypoint in the software, but that waypoint is more
than about 500 feet (152 meters) from the GPS's first fix location.
The Vector has detected that you are commanding the multirotor to
descend by throttling down, but the multirotor is not descending,
possibly due to too high of an idle throttle setting. Please land and
reduce your idle throttle.
This message tells you what you probably already knew. :(
This message appears when you activate the motor kill switch.
This message indicates that the model is landing (normally during RTH)
if the GPS signal or compass calibration is too poor to continue returning
home.
This message is displayed at boot when low battery autoland is enabled,
and you have connected either an almost dead battery, or a battery that
is overcharged. If you have manually defined the number of cells in your
battery for the autoland function, this message will also be displayed if
the detected cell count does not match the stated number.
This message will appear when the data logging buffer is full, if you have
disabled automatic clearing of the logging buffer.
USER GUIDE
91