Hach TU5200 User Manual page 34

Message
Instrument update
Copy from USB Memory
failed
Instrument update file is
missing
Instrument update file is
corrupt
Update script file is corrupt
Not enough memory to
update the instrument
USB memory is not
connected.
Read/Write to USB flash drive
Cannot write to USB
memory
Cannot read from USB
memory
Restore backup
No instrument backup is
available.
Not able to restore the
backup
Security
Invalid password
Send data
Connect a receiving device.
Add sample IDs from list
No valid data found
Not able to read sampling
date.
The instrument cannot read
the Sample ID
Problem/Error: Incorrect
date
Possible cause: The wrong
date format.
32 English
Remove large files from the USB flash drive that use too much space. Start the
instrument update procedure again.
Remove the instrument update files from the USB flash drive. Save the instrument
update files again to the USB flash drive.
Connect the USB flash drive to the instrument. Start the instrument update
procedure again.
Remove the instrument update files from the USB flash drive. Save the instrument
update files again to the USB flash drive.
Connect the USB flash drive to the instrument. Start the instrument update
procedure again.
Contact technical support.
Connect a USB flash drive to the instrument. Make sure that the file system
"FAT32" is installed on the USB flash drive.
Set the power to off, wait 20 seconds and then set the power to on again. Connect
the USB flash drive. Start the instrument update procedure again.
Connect a USB flash drive to the instrument. Make sure that the file system
"FAT32" is installed on the USB flash drive.
Set the power to off, wait 20 seconds and then set the power to on again. Look for
remaining space on the USB flash drive.
Set the power to off, wait 20 seconds and then set the power to on again. Connect
the USB flash drive to the instrument.
Connect a USB flash drive to the instrument. Make sure that the file system
"FAT32" is installed on the USB flash drive.
Set the power to off, wait 20 seconds and then set the power to on again. Connect
the USB flash drive. Start the instrument update procedure again.
Enter the correct password. If the password is lost, contact technical support.
Examine the device connections. Set the Auto Send setting to off. Refer to
Configure the measurement settings
No sample ID file was found on the USB flash drive.
Make sure that the date and time format is dd.mm.yyyy hh:mm.
Examine the text strings. Refer to
Make sure that the date and time format is dd.mm.yyyy hh:mm.
Solution
on page 15.
Import sample IDs (optional) on page 14.