Set Up A Lan Connection; Connect To An Ftp Server Or Netdrive - Hach TU5200 User Manual

4. Select an option.
Option Description
% Sets the acceptance range to a percentage (1 to 99%).
NTU Sets the acceptance range to NTU units (0.015 to 100.00 NTU).
5. Push Value, then enter the acceptance range.

Set up a LAN connection

The manufacturer recommends that a network administrator does this task.
Set up a LAN connection at the instrument to do one or more of the tasks that follow.
• Show the manufacturer's website on the instrument.
• Compare process and laboratory measurements with Link2SC.
• Send data to a network printer that is SNMP enabled.
• Send data to a specific folder on an FTP server.
• Send data to a specific folder on a Netdrive.
• Show the readings from an sc controller(s) on the instrument.
1. Connect the Ethernet port to a LAN with a shielded cable (e.g., STP, FTP, S/FTP).
Note: The maximum permitted length of the shield cable is 20 m (65.6 ft).
2. Push two times, then push Setup.
3. Push Network & Peripherals.
4. Select Network, then push Setup.
5. Select On.
6. Push TU5200 IP.
7. To get an IP address for the instrument from a DHCP server, do the steps that follow.
a. Select Automatic.
b. Push OK two times.
The IP address shows on the TU5200 IP menu icon.
8. To manually enter an IP address for the instrument, do the steps that follow.
a. Select Fixed.
b. Push IP-Address, then enter the IP address.
c. Push Default Gateway, then enter the default gateway.
d. Push Subnet Mask, then enter the subnet mask.
e. Pusk OK two times.
The IP address shows on the TU5200 IP menu icon.
9. To compare process and laboratory measurements with Link2SC, enter the IP address for the
instrument in the sc controller as follows:
a. On the sc controller, select LINK2SC>CONFIGURE>IP ADDRESS.
b. Enter the IP address for the instrument.

Connect to an FTP server or Netdrive

Pre-requisites: Connect the instrument to a LAN. Refer to
Connect the instrument to a folder on an FTP server or Netdrive to send data to that folder.
1. Push two times, then push Setup.
2. Push Network & Peripherals.
3. Select Network, then push Setup.
16 English
Set up a LAN connection on page 16.