Kyocera KM-2810 Service Manual page 53

Maintenance
item No.
Setting the fuser control temperature
U161
Description
Changes the fuser control temperature.
Purpose
Normally no change is necessary. However, can be used to prevent curling or creasing of paper, or solve a
fuser problem on thick paper.
Method
1. Press the start key.
2. Select the item to be set.
3. Change the setting using the cursor left/right keys.
Display
1ST TEMP T1
2ND TENP T2
2ND TENP T2-T2
1ST FEED TEMP
2ST FEED TEMP
PRINT TEMP T3
PRINT TEMP T4
4. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Checking the fuser temperature
U199
Description
Displays the fuser temperature, the ambient temperature.
Purpose
To check the fuser temperature, the ambient temperature.
Method
1. Press the start key. The fuser temperature and ambient temperature are displayed in centigrade (%).
Display
HEAT TEMP
SURROUND TEMP
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Turning all LEDs on
U200
Description
Turns all the LEDs on the operation panel on.
Purpose
To check if all the LEDs on the operation panel light.
Method
1. Press the start key.
2. Select EXECUTE and press the start key.
All the LEDs on the operation panel light.
3. Press the stop key. The LEDs turns off.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Description
Description
Stabilized temperature during operation
Stabilized temperature under suspension
Stabilized temperature under suspension
Primary paper feed start temperature
Secondary paper feed start tempera
Temperature control during printing
Temperature control during printing
Description
Fuser temperature (
Ambient temperature (
Setting range
-30 to 30
-30 to 30
-30 to 30
-30 to 30
-30 to 30
-30 to 30
-30 to 30
°
C)
°
C)
2H9
Initial setting
0
0
0
0
0
0
0
1-3-29