Board; Speaker - Sony PMW-EX1 Service Manual

2-2-20. LED-465 Board
1. Refer to Sections from 2-2-3 to 2-2-5 and
disassemble the unit up to "Handle Assem-
bly" removal.
2. Remove the connector cover from the jack of
the LED-465 board.
3. Remove the three screws of a, and remove
the LED-465 bracket and the LED-465 board
in the direction of the arrow.
4. Remove the two screws of b and the M6
nut, and remove the LED-465 bracket.
5. Disconnect the harness from the connector
(CN11) on the LED-465 board, and remove
the LED-465 board.
6. Reinstall the LED-465 board by reversing the
steps of removal.

2-2-21. Speaker

1. Refer to Sections from 2-2-3 to 2-2-5 and
disassemble the unit up to "Handle Assem-
bly" removal.
2. Refer to Section 2-2-20 and disassemble the
unit up to "LED-465 board" removal.
3. Remove the two screws, and remove the
speaker grill.
4. Remove the speaker holder sheet, and remove
the speaker harness from the slit of the
speaker holder.
5. Remove the speaker from the speaker holder.
6. Reinstall the speaker by reversing the steps of
removal.
PMW-EX1
M6 nut
LED-465 bracket
LED-465 bracket,
LED-465 board
a
: P2 lock ace 2 x 3
b
: P2 lock ace 2 x 3
LED-465 board
b
CN11
a
Connector cover
a
Speaker holder
Speaker grill
P2 lock ace
2 x 3
Speaker
Speaker
holder sheet
Speaker
harness
2-19