Sony PMW-EX1 Service Manual page 36

8. Remove the four screws of e.
9. Remove the bracket carefully not to damage
the HN-319 (flexible board).
m
. The life of the flexible board and the flat
cable will be significantly shortened if they
are folded. Be very careful not to fold
them.
. The coaxial cable with connector uses fine
pitch coaxial cables. Be careful when
arranging the cable. When disconnecting
the coaxial cable with connector, do not
attempt to remove by pulling the cable. Be
sure to hold the connector to remove.
10. Disconnect the harnesses from the connectors
(CN100, CN700) on the HD-SDI assembly.
11. Disconnect the coaxial cable from the
connector (CN200) on the HD-SDI assembly.
n
The characteristic of the heat transfer sheet
(carbon sheet) deteriorates if it is damaged or
folded. Be careful when handling it.
12. Remove the three screws of f, and remove
the HD-SDI assembly.
13. Remove the four screws of g, and remove
the heat spreader.
14. Remove the two screws of h, and remove
the TX-115 board.
15. Reinstall the battery case and the TX-115
board by reversing the steps of removal.
n
When reinstalling the HD-SDI assembly, be
careful not to drop the radiation sheet.
2-12
Bracket
e
e
CN200
CN100
Coaxial cable with
connector
Harness
Note
Do not fold the heat transfer sheet (carbon sheet).
OK
g
HD-SDI
assembly
e
e
: P2 lock ace 2 x 3
f
: P2 lock ace 2 x 3
e
Coaxial cable
f
Heat transfer
f
sheet
HD-SDI
assembly
CN700
HN-319
NG
Heat transfer sheet
g
Heat spreader
Radiation sheet
h
TX-115 board
g
: P2 lock ace 2 x 3
h
: P2 lock ace 2 x 3
PMW-EX1