7 Configuration Example of the Dual-System Hot Backup in
Routing Mode
4.
5.
6.
7.
Step 5 Configure EGW2100 B.
The procedure for configuring the EGW2100 B is the same as that for configuring the
EGW2100 A. The following parameters, however, are different:
l
l
Step 6 Save the configuration.
1.
7-4
Figure 7-5 Configuring VGMP
Click Apply. Then click OK in the Are you sure to submit? dialog box that is displayed
to complete the configuration.
Click the HRP Config tab. The HRP Config page is displayed.
Select the Enable HRP check box.
Figure 7-6 HRP two-node cluster hot backup in routing mode
Click Apply. Then click OK in the Are you sure to submit? dialog box that is displayed
to complete the configuration.
The interface IP addresses of EGW2100 B are different from those of the EGW2100 A.
The default priority of the VRRP management group on EGW2100 B is 100.
Click Save on the upper right of the page to save the configuration.
parameter setting.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 7-6
shows the parameter setting.
HUAWEI EGW2100
Web Configuration Guide
Figure 7-7
shows the
Issue 01 (2010-02-20)