4.4 Configuration Example Of Rip; Figure 4-30 Saving The Configuration - Huawei EGW2100 Web Configuration Manual

HUAWEI EGW2100
Web Configuration Guide
2.
----End

4.4 Configuration Example of RIP

Routing Information Protocol (RIP) is a type of protocol based on the distance-vector (D-V)
algorithm. By using RIP, you can exchange routing information through UDP packets. This
protocol is widely used in simple small-/medium-sized networks.
Networking Requirements
Three subnetworks (192.1.2.0/24, 192.1.3.0/24, and 192.1.4.0/24) in a Local Area Network
(LAN) cooperate with each other through the EGW2100 and two routers. Routing Information
Protocol (RIP) works on both the EGW2100 and routers. After the configuration, the
EGW2100, Router B, and Router C can learn routing information from each other.
The EGW2100, Router B, and Router C respectively serve as the default gateways of the
192.1.2.0/24, 192.1.3.0/24, and 192.1.4.0/24 network segments. The EGW2100 connects to the
Ethernet interfaces of Router B and Router C through Ethernet interfaces. The EGW2100
(192.1.1.1) receives RIP packets broadcasted by Router B (192.1.1.2) and Router C (192.1.1.3).
The EGW2100 sends RIP broadcast packets to Router B and Router C at the same time.
Networking Diagram
Figure 4-31
Issue 01 (2010-02-20)

Figure 4-30 Saving the configuration

Click OK in the This will save current configuration, if you switch to other pages, you
will not get the operation result. Are you sure to save? dialog box that is displayed to
complete the configuration.
shows the networking of the RIP configuration example.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuration Example of the Internetworking
4-15