Figure 4-57 Configuring The Interzone Packet Filtering Rule; Figure 4-58 Configuring The Static Route; Figure 4-59 Enabling The Dhcp Function - Huawei EGW2100 Web Configuration Manual

4 Configuration Example of the Internetworking
11. Click Apply. Then click OK in the Are you sure to submit? dialog box that is displayed
12. Choose NetWork > Route Config. The Route Config page is displayed.
13. Click the Route-Static tab. Click New. The Route-Static Config page is displayed.
14. Click Apply. Then click OK in the Are you sure to submit? dialog box that is displayed
Step 7 Configure the DHCP function, which can dynamically assign IP addresses to intranet users.
1.
2.
3.
4-28

Figure 4-57 Configuring the interzone packet filtering rule

to complete the configuration.
4-58 shows the parameter setting.

Figure 4-58 Configuring the static route

to complete the configuration.
Choose Service > DHCP > DHCP Basic. The DHCP Basic Config page is displayed.
In the DHCP Basic Config group box, select the DHCP Enable check box. Click OK in
the Are you sure to enable? dialog box to enable the DHCP function.
the parameter setting.

Figure 4-59 Enabling the DHCP function

In the Setting Interface Process Mode Of DHCP Packet group box, configure the
processing mode for DHCP packets on Ethernet0/0/0.
setting.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
HUAWEI EGW2100
Web Configuration Guide
Figure 4-59
Figure 4-60 shows the parameter
Issue 01 (2010-02-20)
Figure
shows