Siemens HiPath HG 1500 Service Manual page 17

lan2de.c02
Installation
LAN boards for Hicom OfficePoint/Com/Pro
Interfaces/connectors
The LAN port is linked at the X3 connector. For connector assignment, see Table 2-3.
The board is equipped with a 50-pin edge connector to the system, two Western
sockets (8-pin, 10-pin shielded) to the LAN and a shielded MiniDin socket (6-pin) for
the V.24 interface:
X1: 50-pin to the system
X2: 6-pin shielded MiniDin socket for V.24 interface, see Section 2.1.3
The following connection option is provided for connection to a LAN:
X3: 8-pin Western socket for LAN 10/100 Base-T, RJ45 socket (twisted pair)
LAN
connec-
tion
Figure 2-1
A twisted-pair cable is used as the transmission medium for 10/100 Base-T".
The cable is connected to the HiPath HG 1500 board HXGS (OfficeCom and
OfficePoint) via the 8-pin Western socket (X3) located on the MDF-side of the circuit
board, see Figure 2-1 .
2-2
X2 V.24
X3 10/100 Base-T
HXGS interfaces (S30810-Q2931-X/X100)
HXGS
A31003-K5020-S100-4-7620
For internal use only
50
X1
to
CUC/
CUP
2
Service Manual