KANEXPRO
IR sensor
③
LCD Screen
④
INPUT selector
⑤
button
OUTPUT selector
⑥
button
Rear Panel
INPUTS
1
2
3
No.
Name
INPUTS
①
OUTPUTS
②
CONTROL
③
DC 24V
④
Ground
⑤
Pictures shown in this manual are only for reference.
8 |
P a g e
Built-in IR sensor, receive IR signal sent from IR
remote.
Displays real-time operation status.
Total 4 input selector buttons, press one of buttons to
switch input source.
Total 4 output selector buttons, press the buttons to
select output channel.
SPDIF
4
1
2
Figure 2- 2 Rear Panel
Description
HDMI input ports, 4 in total, connect with HDMI
sources.
SPDIF: audio output ports for de-embedded HDMI
audio, 4 in total.
HDMI: 4 in total, connect with HDMI displays.
EDID: 4-pin EDID DIP switchers to set EDID data, "1"
stands for "On", "0" stands for "Off". Refer to 4.2 EDID
Configurarion for more detials.
RS232: Serial control port, connect with control device.
IR IN: Connects with external IR receiver for using the IR
remote to control the Matrix Switcher.
TCP/IP: Connect control PC for TCP/IP control.
Connect with 24VDC 1.25A power adaptor.
Connect to ground.
OUTPUTS
SPDIF
SPDIF
3
4
HDMX44-18G
CONTROL
On
1
SPDIF
Off
0
1 2 3 4
Tx
Rx
ON DIP
1 2 3 4
EDID
R S232
IR IN
TCP/IP
DC 24V