Panel Button Control; I/O Connection Switching; Edid Configuration - KanexPro HDMX44-18G User Manual

KANEXPRO

4. Panel Button Control

4.1 I/O Connection Switching

The front panel features four input selection buttons and four output selection buttons
for switching I/O connection.
To convert one input to an output:
1.
Example: Input 1 to Output 3
→ Press INPUTS 1 + OUTPUTS 3
To convert an input to several outputs:
2.
Example: Convert Input 2 to Output 3 and 4
→ Press INPUTS 2 + OUTPUTS 3 + OUTPUTS 4
NOTE: Indicators of the pressed buttons will blink green three times if the conversion
is done, then it will turn off. If the conversion failed, they will turn off immediately.

4.2 EDID Configuration

The rear panel boasts a 4-pin EDID DIP switcher to manage EDID. The EDID data and
its corresponding DIP switcher status are shown in the below list.
DIP Switcher
11 | P a g e
NO. Status EDID
0 0000 Pass though (default)
1 0001 720P 2D Pass though CH
2 0010 720P 3D Pass though CH
3 0011 1080P 2D Pass though CH
4 0100 1080P 3D Pass though CH
5 0101 4K@30HZ Pass though CH
6 0110 4K@30HZ 2.0CH
7 0111 4K@30HZ 7.1CH
8 1000 4K@60HZ 4:2:0 Pass though CH
9 1001 4K@60HZ 4:2:0 7.1CH
10 1010 4K@60HZ 4:4:4 Pass though CH
11 1011 4K@60HZ 4:4:4 7.1CH
Enable Software EDID management
1111 mode: RS232 control or Web-based
GUI control
HDMX44-18G