Replacing Batteries; Care And Maintenance - Emos T15RF Manual

Defrost mode
1. Press the and
The and icons will be displayed and the
2. Press any button (except
3. Default temperature for the defrost mode is 7 °C.
Display backlight
Press the BACK-LIGHT button to switch on the display backlight. If no button is pressed within
10 seconds, backlight goes out.

Replacing batteries

Replace batteries when the battery icon is shown on the display.
1. Switch off power of the receiver unit.
2. Remove the control unit rear cover.
3. Replace batteries with new alkaline AA type batteries.
4. Replace the rear cover.
5. Press the RESET button once and than power the receiver unit.
Adaptive Recovery Configuration
Adaptive Recovery Configuration (ARC) minimises the need for heating or cooling
when the program setting was changed and you want to reach a new temperature level.
ARC is activated when the program setting has been changed, the comfort mode is to begin, and
the room temperature is to be reached.
Therefore, the ARC is only activated in the heating mode if the current set temperature is lower
than the upcoming set temperature of the program. In the cooling mode, the ARC is only activated
if the current set temperature is higher than the upcoming temperature.
The ARC changes the room temperature gradually using the heating or cooling systems. The set
temperature begins to change to the upcoming temperature of the comfort mode timely in advance
of the scheduled time of the next program.
The time when the ARC is switched on depends on the difference between the current room tem-
perature and the set temperature of the upcoming comfort program. The greater the difference,
the sooner the ARC turns on. The minimum time is 10 minutes, the maximum time is 50 minutes.

Care and maintenance

The product is designed to provide trouble-free service for many years if operated appropriately.
Here is some advice for proper operation:
• Read carefully the manual before using this product.
• Do not expose the product to direct sunlight, extreme cold and moisture, and sudden changes
in temperature. This would reduce the accuracy of detection.
• Do not place the product in locations prone to vibration and shocks – these may cause damage.
• Do not expose the product to excessive force, impacts, dust, high temperatures or humidity - these
may cause malfunction, shorter battery life, damage to batteries and deformation of plastic parts.
• Do not expose the product to rain or high humidity, dropping or splashing water.
• Do not place any open flame sources on the product, e.g. a lit candle, etc.
• Do not place the product to places with inadequate air flow.
• Do not insert any objects in the product vents.
• Do not tamper with the internal electric circuits of the product – you may damage it, which
will automatically terminate the guarantee. The product should only be repaired by a qualified
professional.
• To clean the product, use a slightly moistened soft cloth. Do not use solvents or cleaning agents
- they could scratch the plastic parts and cause corrosion of the electric circuits.
simultaneously to activate the defrost mode (for the heating mode only).
) to exit the defrost mode.
8
and will disappear.