Installing HDD/SSD cage
1
Align the screw holes on the interposer with the screw holes on the drive cage.
2
Replace the four screws (M2X3) that connect the interposer to the drive cage.
3
Align the screw holes on the hard-drive cage to the screw holes on the middle frame.
4
Replace the four screws (M3X4) that secure the drive cage to the middle frame.
5
Connect the HDD/SSD cables and the HDD/SSD power cable to the system board.
NOTE:
Connect the blue-colored cable at the top and red-colored cable to the bottom of the drive cage.
6
Route the cables through the guide and close the clip to secure the cables.
7
Install the:
a
I/O panel
b
system-board shield.
c
stand
d
hard drive
e
back cover
f
USB dongle-bay cover
8
Follow the procedure in
Converter board
Removing converter board
1
Follow the procedure in
2
Remove the:
a
USB dongle-bay cover
b
back cover
c
stand
d
system-board shield
e
inner frame
f
I/O panel
3
Disconnect the left backlight power cable from the converter board [1].
4
Disconnect the converter-board cable from the converter board [2].
5
Disconnect the right backlight power cable from the converter board [3].
After working inside your computer
Before working inside your
computer.
Removing and installing components
47