Electrolux EOB8857AAX User Manual page 52

52 www.electrolux.com
Problem
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The lamp does not oper‐
ate.
The display shows F111.
The display shows an error
code that is not in this ta‐
ble.
Steam and condensation
settle on the food and in
the cavity of the oven.
The descaling procedure is
interrupted before it finish‐
es.
The descaling procedure is
interrupted before it finish‐
es.
There is no water inside
the grill- / roasting pan af‐
ter the descaling proce‐
dure.
Possible cause
The automatic switch-off is
activated.
The Child Lock is on.
The door is not closed cor‐
rectly.
The fuse is blown.
The lamp is defective.
The plug of the core tem‐
perature sensor is not cor‐
rectly installed into the
socket.
There is an electrical fault.
You left the dish in the
oven for too long.
There was a power cut.
The function was stopped
by the user.
You did not fill the water
drawer to the maximum
level.
Remedy
Refer to "Automatic switch-
off".
Refer to "Using the Child
Lock".
Fully close the door.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Put the plug of the core
temperature sensor as far
as possible into the socket.
• Deactivate the oven
with the house fuse or
the safety switch in the
fuse box and activate it
again.
• If the display shows the
error code again, con‐
tact the Customer Care
Department.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
Repeat the procedure.
Repeat the procedure.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.