3.
Figures 9–10
Note: The pivot arm bracket bushing is
shipped with a lubricating grease coating on
its outside surface. This lubricant will keep
the motion of the pivot arm smooth during
operation and reduce the wear on the metal-
to-metal surfaces.
Figure 9.
Figure 10.
4.
Note: Make sure the four set screws do
not make contact with the other part of the
assembly.
5.
Figure 11.
6.
7.
Note: Before fully tightening the mounting
hardware, make sure that the three cap
screws and four set screws of the arm brack-
et assembly are loose. This will allow the
mounting bracket to lay flat on the mounting
surface.
8.
Figures 9–10
9.
Figure 11
Figures 9–10