Table of Contents
Advertisement
5 SETTINGS AND PROCEDURES UP UNTIL OPERATION
5.6 Setting from the GX Developer
5.6.1 I/O assignment settings
Item Name
Type
Model name
Number of points Sets 32 points.
I/O assignment
Header XY
Switch settings
Detailed settings When a multiple CPU system is being used, this sets the control CPU for the QD51 (-R24).
Multiple CPU setting
5 - 11
Here, the various settings from the GX Developer which are necessary in order to
carry out data communications with an external device from the QD51 (-R24) are
explained.
[Setting purpose]
I/O assignment settings are used to set the type of each module installed in the
base module, to set the input/output signal ranges and to set the QD51 (-R24)
switches.
[Start procedure]
[GX Developer]
Refer to the Operating Manual for the GX Developer concerning screen display
methods.
[Setting screen]
[Display contents]
Sets "Intelligent"
Sets the model name of the installed module (QD51 or QD51-R24).
Sets the header input / output (hexadecimal) of the relevant module.
Sets the console, debugger and mode setting switch, etc.
Carries out settings when a multiple CPU system is used.
[PC Parameters]
I/O Assignment Setting
Item Setting Contents
MELSEC-Q
Remarks
Refer to Section 5.6.2.
Refer to QCPU User's Manual
(Multiple CPU system).
5 - 11
Advertisement
Table of Contents
