Volkswagen Golf 2004 Workshop Manual page 262

Golf 2004 ➤
General body repairs, exterior - Edition 04.2008
4.9.2 Installing
Note
The securing screws for the retaining strip are corrosion-re‐
♦
sistant. No further secondary treatment is required.
If a screw is overtightened, it is essential to replace it with a
♦
"black" oversize screw.
• There are no pre-drilled holes for the securing screws.
– Measure holes according to the table below.
– Mark holes for securing screws with centre punch.
– Drill out holes with a 1.5 mm drill bit.
254
Rep. Gr.66 - Exterior equipment