Volkswagen Golf 2004 Workshop Manual page 101

Golf 2004 ➤
General body repairs, exterior - Edition 04.2008
1.6.2 Adjusting door fittings for flushness
Use bolts -2, 3, 4, 5 and 6- on hinge to adjust correctly for flush‐
ness.
Use door alignment tool -3320- with bit -3320/3- .
– Adjusting upper area of door, loosen bolts -5 and 6-.
– Specified torque for bolt -5-: 10 Nm.
– Specified torque for bolt -6-: 50 Nm.
– To adjust lower area of door, loosen bolts -5 and 6-.
– Specified torque for bolt -2-: 10 Nm.
– Specified torque for bolts -3 and 4-: 50 Nm.
The bolts -3, 4 and 6- must always be renewed if loosened.
– Guide pin -4- may be ground down if necessary.
93
1. Rear door