Table of Contents
Advertisement
Acpi1.0B / Acpi3.0 /
ACPI selection
Acpi4.0 / Acpi5.0
Enabled / Disabled
USB Boot
EFI device first
EFI/Legacy Device Order
Legacy device first
Smart Mode
Enabled / Disabled
UEFI OS Fast Boot
USB Hot Key Support
Enabled / Disabled
0 ÷ 10
Timeout
Automatic Failover
Enabled / Disabled
EFI
See Submenu
Legacy
See Submenu
X86
UDOO X86 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: S.B. - Reviewed by M.B. Copyright © 2017 SECO S.r.l.
Using this menu item is possible to select to which specifications release the ACPI tables must be
compliant.
Disables or enables booting from USB boot devices.
This submenu is available only when "Boot Type" is set to Dual Boot Type.
Determine if boot must happen first through EFI devices or through legacy devices, or in Smart Mode.
This submenu is available only when "Boot Type" is set to UEFI Boot Type.
If enabled, the system firmware does not initialize keyboard and check for firmware menu key.
Available only when "Boot Type" is set to UEFI Boot Type and "UEFI OS Fast Boot" is Enabled.
Enable or disable the support for USB HotKeys while booting. This will decrease the time needed to boot
the system
The number of seconds that the firmware will wait before booting the original default boot selection.
When this item is enabled, if boot from the default device fails, then the system will attempt directly to boot
from the next device on the Boot devices list
When this item is disabled, in case of failure from booting from the first boot device, then a Warning
Message will pop up and subsequently enter into Firmware UI.
This submenu is available only when "Boot Type" is not set to "Legacy Boot type".
The submenu will show a list of EFI boot devices. Use F5 and F6 key to change order for boot priority.
This submenu is available only when "Boot Type" is not set to "UEFI Boot type".
Allows setting of Legacy Boot Order
56
Advertisement
Table of Contents
