Advanced Menu - Seco Udoo X86 User Manual

4.3 Advanced menu

Menu Item Options
Boot Configuration See submenu
Security configuration See submenu
Video Configuration See submenu
Chipset Configuration See submenu
ACPI Table / Features Control See submenu
SATA Configuration See submenu
Console Redirection See submenu
POST Hot Key See submenu
Other Configuration See submenu
4.3.1 Boot configuration submenu
Menu Item Options
OS Selection Windows / Android
Numlock On / Off
4.3.2 Security configuration (TXE) submenu
Menu Item Options
TXE HMRFP0 Disabled / Enabled
TXE Firmware update Disabled / Enabled
TXE EOP Message Disabled / Enabled
Yes / No
TXE Unconfiguration Perform
Measured boot Disabled / Enabled
X86
UDOO X86 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: S.B. - Reviewed by M.B. Copyright © 2017 SECO S.r.l.
Description
Configures settings for Boot Phase
Trusted Execution Environment Security Configurations
Configures the options for video section
Configure Chipset's parameters
Configures the parameters for ACPI management
Select the SATA controller and hard disk drive type installed in the system
Configures the parameters for Console redirection
Configure POST Hot Keys
Other parameters settings
Description
Configures the BIOS in order to support properly Windows or Android OS.
Allows to choose whether NumLock Key at system boot must be turned On or Off
Description
Enable this option to remove temporarily the flash protection, in order to program the Intel
Enable this option to require a re-flashing of TXE Firmware Image
Send EOP (End of POST) Message before entering OS
Only selectable on CPUs with the TXE feature.
Allows to revert TXE settings to the factory defaults
Enable or disable the measured boot, which provide to antimalware software a trusted log of all boot
components that started before the antimalware software itself.
®
TXE region
41