Table of Contents
Advertisement
4.6 Boot menu
Menu Item
Options
Dual boot Type
Boot type
Legacy Boot Type
UEFI Boot Type
Quick Boot
Enabled / Disabled
Quiet Boot
Enabled / Disabled
Display Boot Logo
Enabled / Disabled
Logo persistence Time (s)
0 ÷ 10
Display ESC Key Strings
Enabled / Disabled
Network Stack
Enabled / Disabled
Disabled
UEFI : IPv4
UEFI : IPv6
PXE Boot Capability
UEFI : IPv4/IPv6
Legacy
Enabled / Disabled
PXE Boot to LAN
Power Up in Standby Support
Enabled / Disabled
Add Boot options
First / Last / Auto
X86
UDOO X86 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: S.B. - Reviewed by M.B. Copyright © 2017 SECO S.r.l.
Description
Allows to select if the OS must be booted using Legacy Boot Mode, UEFI Boot mode or indifferently using
both modalities (depending on the OS)
Skip certain tests while booting. This will decrease the time needed to boot the system.
Disables or enables booting in Text Mode.
Enable or display the visualization of a logo during Boot phase
This submenu is available only when "Display Boot Logo" is set to Enabled.
Forced wait time in seconds during the boot logo visualization. 0 means boot as fast as possible. Even with
0 wait time. UEFI OSes supporting BGRT table will display the logo while booting.
Display or Hide the "ESC key" strings during the BIOS boot. Disabling this configuration, no information on
how to enter Setup Configuration Utility will be displayed.
This submenu is available only when "Boot Type" is set to "UEFI Boot type" or "Dual Boot type".
When enabled, this option will make available the following Network Stack services:
Window 8 BitLocker Unlock
UEFI IPv4 / IPv6 PXE
Legacy PXE OpROM
This submenu is available only when "Network Stack" is Enabled
Specifies the PXE (Preboot Execution Environment) Boot possibilities.
When Disabled, Network Stack is supported
For UEFI, it supports IPv4, IPv6 or both
In Legacy mode, only Legacy PXE OpROM is supported
This submenu is available only when "Boot Type" is set to "Legacy Boot type".
Disables or enables the possibility for the PXE to perform the boot from LAN.
Disable or enable Power Up in Standby Support. The PUIS feature set allows devices to be powered-up in
the Standby power management state to minimize inrush current at power-up and to allow the host to
sequence the spin-up of devices.
Specifies the position in Boot Order for Shell, Network and Removable Disks
55
Advertisement
Table of Contents
