Table of Contents
Advertisement
4.5 Power menu
Menu Item
Options
Advanced CPU Control
See submenu
EC Watchdog Configuration
See submenu
Thermal Zone configuration
See submenu
Always ON
Power Fail Resume Type
Always OFF
WiFi on M.2
Enabled / Disabled
Bluetooth on M.2
Enabled / Disabled
Instant OFF
Enabled / Disabled
Enabled
Curie Power Management
Wake Only
Disabled
Power on Intel Curie
Enabled / Disabled
Curie reset on Power On
Enabled / Disabled
Enabled
Infrared Support
Wake Only
Disabled
Wake on PME
Enabled / Disabled
X86
UDOO X86 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: S.B. - Reviewed by M.B. Copyright © 2017 SECO S.r.l.
Description
These items control various CPU parameters
Embedded Controller Watchdog Configuration Settings
Thermal Zone Configuration: Active and Passive Cooling Settings.
Determine the System Behavior after a power failure event.
In case the option is "Always ON", the board will start every time the power supply is present.
When the option is "Always OFF", the board will not start automatically when the power supply returns.
A CMOS Battery is required to support this feature, otherwise the chipset default setting is Always ON.
Enables or disables the WiFi capabilities of WiFi cards plugged into M.2 slot CN19.
Enables or disables the BT capabilities of BlueTooth cards plugged into M.2 slot CN19.
In non-ACPI environments, this item will enable the system shut-down by a power button pressure.
Enables or disables the system power-on and power-
signal (CN13 pin 3, active low 20ms pulse).
When "Wake Only"
depending on OS configuration) and wake from it
If enabled, it will power-on the Arduino interface
power state (S3/S4/S5)
Enables or disables the system power-on and power-off managed by the Infrared Remote Control.
When disabled, the Infrared Receiver will be unconditionally disabled.
When "Wake Only", the Infrared Receiver will only be able to wake the system from S3/S4/S5
When enabled, the Infrared Receiver will be able both to put the system in a low power state (S3/S4/S5,
depending on OS configuration) and wake from it
Determines whether the system must wake up or not when the system power is off and occurs a PCI
Power Management Enable wake-up event (e.g. to enable Wake on LAN feature).
ly be able to wake the system from S3/S4/S5
-
51
Advertisement
Table of Contents
