Introduction - Seco Udoo X86 User Manual

3.1 Introduction

On UDOO x86 board, there are several connectors located on the upper plane. Standard connectors are placed on the same side of PCB, so that it is possible to
place them on a panel of an eventual enclosure.
Please be aware that, depending on the configuration purchased, the appearance of the board could be slightly different from the following pictures.
TOP SIDE
Buttons/LED UDOO bricks
CIR Receiver
header connector
FAN connector
Arduino interface
+ expansion
connector #1
Arduino interface
+ expansion
connector #3
USB 3.0 Port #2 Gigabit Ethernet
DC Power jack
connector RJ-45 connector
X86
UDOO X86 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: S.B. - Reviewed by M.B. Copyright © 2017 SECO S.r.l.
USB 3.0 Ports #0 Mic + Headphone
Speaker headers
#1 connectors TRRS socket
Embedded
controller JTAG
(reserved)
Arduino interface
+ expansion
connector #2
Arduino interface
+ expansion
connector #4
JTAG connector
miniDP++ miniDP++
HDMI connector
connector #1 connector #2
BOTTOM SIDE
Cabled RTC
µSD Card Slot
SPI Header
battery connector
M.2 WWAN/SSD
SATA power
SATA Connector Slot (Socket 2
connector
Key B)
M.2 Connectivity
Slot (Socket 1 key
E)
21