Acpi Table/Features Submenu - Seco Udoo X86 User Manual

Non-Common Clock with SSC Enabled Mode
Tx Eq Deemphasis Selection

4.3.5 ACPI Table/features submenu

Menu Item
FACP - RTC S4 wakeup
FACP - Preferred PM Profile
DSDT - ACPI S3 Support
DSDT - ACPI S4 Support
WDAT/WDRT - TCO Watchdog Support
4.3.6 SATA configuration submenu
Menu Item Options
SATA Controller Enabled / Disabled
SATA Interface Speed Gen1 / Gen2 / Gen3
SATA Test mode Enabled / Disabled
Aggressive LPM Support Enabled / Disabled
SATA Port 0 / SATA Port 1 Enabled / Disabled
Serial ATA Port 0 / 1
X86
UDOO X86 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: S.B. - Reviewed by M.B. Copyright © 2017 SECO S.r.l.
Disabled / Enabled Assume the root port is operating at non-common clock with SCC enabled.
6 dB / 3.5dB Select the level of de-emphasis for an Upstream component.
Options Description
Enabled / Disabled Enable or disable FACP (Fixed ACPI Description Table) support for S4 wakeup from RTC
Auto / Desktop / Mobile This Option sets the preferred power management profile in ACPI Fixed ACPI Description Table
Enabled / Disabled Enable or disable DSDT (Differentiated System Description Table) support for ACPI S3 State
Enabled / Disabled Enable or disable DSDT (Differentiated System Description Table) support for ACPI S4 State
Enabled / Disabled Enable or disable the TCO Watchdog Support
Description
Disabled: Disables SATA Controller. All following items will be disabled
Enabled: Enables SATA Controller
Select SATA speed
Enables or disables SATA Test Mode
Enable or disable the PCH to enter the Aggressive Link Power Management protocol, which allows placing
SATA devices in low power state when inactive for energy saving, with the drawback of an increased
latency when it is necessary to re-activate the SATA device
Enables or disable SATA Port #0 (M.2 Slot CN17) / SATA Port #1 (SATA Connector CN18). When
enabled, each port will offer the following menu item
Shows information related to eventual devices connected to SATA ports 0 or 1
46