Brother DCP-L8410CDW Online User's Manual page 565

Hide thumbs Also See for DCP-L8410CDW:
Table of Contents

Advertisement

Error Message
Supplies
Toner Low: X
(X indicates the toner cartridge
or drum unit colour that is near
the end of its life. BK=Black,
C=Cyan, M=Magenta,
Y=Yellow.)
Supplies
WT Box End Soon
Toner Error
Too Many Trays
Touchscreen
Initialisation Failed
Tray 2 Error
Tray 3 Error
Tray 4 Error
Unusable Device
Unusable Device
Remove the Device. Turn
the power off and back
on again.
Wrong Paper Size MP
Wrong Paper Size T1
Wrong Paper Size T2
Wrong Paper Size T3
Wrong Paper Size T4
Related Information
Troubleshooting
Transfer Your Faxes or Fax Journal Report
Replace Supplies
Load and Print Using the Paper Tray
Load and Print Using the Multi‑purpose Tray (MP Tray)
Replace the Drum Unit
Clean the Corona Wires
Print a Fax Stored in the Machine's Memory
Cause
If the LCD displays this
message, you can still print.
The toner cartridge is near the
end of its life.
The waste toner box is almost
full.
One or more toner cartridges
are not installed or not installed
correctly.
The number of installed
Optional Trays exceeds the
maximum number.
The Touchscreen was pressed
before the power on
initialisation was completed.
Debris may be stuck between
the lower part of the
Touchscreen and its frame.
The optional lower tray is not
installed correctly.
A USB device or USB Flash
memory drive that is encrypted
or not supported has been
connected to the USB direct
interface.
A defective USB device or a
high power consumption USB
device has been connected to
the USB direct interface.
The specified tray ran out of
paper during copying and the
machine could not feed the
same size paper from the next
priority tray.
Action
Order a new toner cartridge before the LCD
displays Replace Toner.
Order a new waste toner box before the LCD
displays Replace WT Box.
Pull out the drum unit. Remove all the toner
cartridges, and then put them back into the drum
unit.
Reduce the number of Optional Trays.
Make sure nothing is touching the Touchscreen.
Insert a piece of stiff paper between the lower part
of the Touchscreen and its frame and slide it back
and forth to push out any debris.
Reinstall the lower tray.
Unplug the device from the USB direct interface.
Unplug the device from the USB direct
interface.
Press and hold
to turn the machine off,
and then turn it on again.
Refill the paper in the paper tray.
558

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mfc-l9570cdwMfc-l8690cdwMfc-l8900cdw

Table of Contents