Mounting In Hanging Position (Head Down); Securing The Fixture - GLP IMPRESSION X4L Instruction Manual

2.2.2 Mounting in hanging position (head down):

To operate the I M
I M
brackets can be mounted directly to the bottom of the base using the
four (4) Camlock connectors.
Alternatively two (2) half-couplers (clamps or hooks) can be mounted directly to
the bottom side of the fixture using the two (2) M10x16 mm thread bolts.
Attention: Never use a longer bolt as this may damage the interior of the
fixture.

2.3 Securing the Fixture

Regardless of the mounting method of the
a stipulated safety wire. Attach the safety wire through one of the two holes
provided on the base of the fixture and connect it to the primary support structure.
Pay attention to a safe and proper fastening. The safety cable must comply with
EN 60598-2-17 Section 17.6.6 and be capable of bearing a static suspended load
that is ten times the weight of the fixture and all installed accessories.
impression X4 L manual (v0.2)
P R E S S I O N X 4 L in a hanging position two (2) omega
P R E S S I O N X 4 L
GLP  German Light Products GmbH
I M P R E S S I O N X 4
I M P R E S S I O N X 4
from software version: v0.xx
L you'll have to use
L
8