Installing A Patch Step-By-Step - H3C S5500-HI Series Fundamentals Configuration Manual

After you execute the command, the system displays the "Do you want to continue running patches after
reboot? [Y/N]:" message. If you enter:
• y or Y: All of the specified patches are installed, and turn to the RUNNING state from IDLE. This
equals execution of the commands patch location, patch load, patch active, and patch run. The
patches remain RUNNING after system reboot.
n or N: All of the specified patches are installed and turn to the ACTIVE state from IDLE. This equals
•
execution of the commands patch location, patch load and patch active. The patches turn to the
DEACTIVE state after system reboot.
Follow these steps to install the patches in one step:
To do...
Enter system view
Install the patches in one step
NOTE:
The patch matches the software version.
•
If you install a patch file by specifying the directory where the patch file locates, the patch install
•
command will change the patch file location specified with the patch location command to the directory
specified by the
If you install a patch file by specifying the filename of the patch package, the patch install command will
•
not change the patch file location specified with the patch location command.
To uninstall all patches in one operation, use the undo patch install command, which is the same as
•
performing
patches in one operation.

Installing a patch step-by-step

Step-by-step patch installation enables you to control the patch status during the patch installation
process.
Step-by-step patch installation task list
Task
Configuring the patch file location
Loading a patch file
Activating patches
Use the command...
system-view
patch install { patch-location | file
patch-package }
patch-location
argument of the patch install command.
"Uninstalling a patch step-by-step." In an IRF fabric, H3C recommends that you uninstall all
Remarks
Optional
To install a patch package, skip this step.
Required
Required
123
Remarks
—
Required
•
patch-location: Specifies the
directory where the patch file
locates. Provide this argument
when you install a patch file
which is not packaged in a
patch package file.
•
file patch-location: Specifies
the name of the patch package
file. Provide this option when
you install a patch package file.