Default Settings; Serial Port Settings - Honeywell PC42d User Instructions

Appendix B - Default Settings

Default settings

Use this Appendix to check the printer's default settings. If you had restored the printer
to its factory default values, it will use the values listed here. The settings' sequence is
similar to the layout in the printer's web page.

Serial port settings

This section explains the serial port settings. To check the settings:

Note: Unless you have installed the optional serial port on the printer and it is
connected to your PC, you will not be allowed to access the settings.
Serial port settings
Settings Description
The serial port's transmission speed, designated in bit per second (bps).
Baud Rate
Data Bits The bits that define a character or byte.
Parity Designates the manner in which the printer examines the integrity of
transmitted data.
Stop Bit This is the bit number at the end of each character. It allows the
signal-receiving hardware to check the character's end and resume
synchronization with the character.
Hardware This checks whether the designated hardware flow-control (RTS/CTS) is
being used to manage rate of data transmission between the equipment
and main unit.
ENQ/ACK This checks whether the designated software flow-control (ENQ/ACK) is
being used to manage rate of data transmission between the equipment
and main unit.
XON/XOFF to This checks whether the designated software flow-control (XON/OFF) is
being use to manage rate of data transmission of the main unit.
XON/XOFF from This checks whether the designated software flow-control (XON/OFF) is
being use to manage rate of data transmission of the main unit.
The defines the printer's echo to the main unit as indication that it has
Line Feed
Character moved to character in the new line.
User Instructions for PC42d Desktop Printer
On the printer web page, click 'Configure' option > 'Communications' >
'Serial'.
Default Value
115200
8
None
1
Disabled
Disabled
Disabled
Disabled
CR/LF
43