Honeywell PC42d User Instructions page 54

Medium Settings (continued)
Setting Description
Medium length If the length of the label with intervals or black label exceeds 6
inches (15.54 cm), manual setting of the label's actual length would
be required when making medium alignment.
Editing default value Check whether the printer is able to print items that are outside the
printable area of the label.
When the setting is 'disabled', and the printer is unable to print any
part of the bar code label because it exceeds the printable area, the
printer will return an error. When the setting is 'enabled', the printer
will print all bar code labels. However it may also print unreadable,
incomplete labels.
Start adjustment Sets the medium length for delivery (positive value) or recover
(negative value) before the printer prints the labels. The unit of
measurement is defined based on "Measurement Unit"
specification. Its range is -9999 to +9999.
Stop adjustment Sets the medium length for delivery (positive value) or recover
(negative value) after the printer prints the labels. The unit of
measurement is defined based on "Measurement Unit"
specification. Its range is -9999 to +9999.
Medium alignment Selects the mode used by the printer for aligning medium. If the
mode printer is unable to identify the intervals between the medium or
markings, it will use "slow speed" mode.
In the case of small labels with intervals, selection of "fast speed"
mode during alignment of medium will reduce wastage of labels.
If the "medium alignment mode" is set at "slow speed", the printer
Length (slow mode)
will in addition to the medium's length, print another 10 mm. The
value is for the additional number of medium to be printed. The unit
of measurement is defined based on "Measurement Unit"
specification. Its range is 80 to 3200..
46
Appendix B - Default Settings
Medium
length
User Instructions for PC42d Desktop Printer
Default Value
1200 points
Disabled
-148 points
0 point
Slow speed
0 point