Self-Tapping - Gold's Gym XRS 50 User Manual

Frame Assembly
2. To make assembly easier, read the information
on page 8 before you begin.
Attach the Stabilizer (2) to the Base (1) with two
M10 x 68mm Bolts (71), two M10 Washers (57),
and two M10 Locknuts (56). Do not tighten the
Locknuts yet.
Identify the two Lower Weight Guides (25), which
have threaded upper ends. Insert the lower ends
of the Lower Weight Guides into the Base (1)
and into the Stabilizer (2).
See the inset drawing. Insert two M10 x 25mm
Button Bolts (77) upward into the Base (1) and
into the Stabilizer (2), and tighten the Button
Bolts into the Lower Weight Guides (25).
Then, attach the Base Foot (19) to the Base (1)
with two M4 x 19mm Self-tapping Screws (69).
3. Insert the Front Base (78) into the Base (1).
Then, insert two M8 x 63mm Carriage Bolts (87)
upward into the indicated holes in the Base (1).
Note: The M8 x 63mm Carriage Bolts (87) will be
used in the next step.
2
2
71
1
3
78
1
9
Threads
25
25
57
56
57
71
25
2
1
77
19
69
Holes
87