HP 54616B User And Service Manual page 37

Using the position knob in the Vertical section of the front panel,
3
move the trace up and down about one division.
Notice that the last acquired waveform is in full bright and the previously
acquired waveforms are displayed in half bright.
•
To characterize the waveforms, use the cursors. See "To make cursor
measurements" on page 2-23.
•
To clear the display, press
•
To exit the Autostore mode, press either
or .
Autostore
Summary of storage keys
Run – The oscilloscope acquires data and displays the most recent trace.
Stop – The display is frozen.
Autostore – The oscilloscope acquires data, displaying the most recent trace in
full bright and previously acquired waveforms in half bright.
Erase – Clears the display.
Operating Your Oscilloscope
To use storage oscilloscope operation
.
Erase
Run
2–7