Populating Memory Modules; Installing Dimm Memory Modules; Removing Memory Modules - Supero A1SAi-2550F User Manual

A1SAi & A1SRi Series Motherboard User's Manual

Populating Memory Modules

Note 1: Install the desired number of DIMMs into the memory slots, starting
with DIMMA1, then DIMMB1, then DIMMA2, then DIMMB2. Pay attention
to the notch along the bottom of the module to prevent incorrect DIMM
module installation. DIMMB1/B2 are not available on A1SRi-2358F.
Note 2: The motherboard will support one, two, or four DIMM modules.
However, for best memory performance, please install DIMM modules in
pairs.
Note 3: Insert only identical memory modules of the same part number
into the memory slots to ensure that only memory modules of the same
type, same frequency, same speed and same capacity are used on the
same motherboard.

Installing DIMM Memory Modules

1. Align the key on the bottom of the DIMM module against the receptive point
on the memory slot. Take note of the notches on the side of the DIMM mod-
ule, and of the locking clips on the socket to avoid causing damage.
Module Key
Socket Key
2. Install the DIMMs module straight down into the socket until it is securely
seated in the socket. The side clips will automatically lock the module into
place.

Removing Memory Modules

Use your thumbs to gently push the side clips near both ends away from the module
to release it from the socket. Once the module is loosened from the socket, pull
the DIMMs module upwards.
Module Notch
Side Clips
2-6