Table of Contents
Advertisement
2-4 Installing DDR4 Memory
Note: Check the Supermicro website for recommended memory
modules.
Attention! Exercise extreme care when installing or removing
DIMM modules to prevent any possible damage.
DIMM Installation
1. Insert the desired number of
DIMMs into the memory slots,
starting with DIMMB2 (refer to
the next page for the location).
For the system to work properly,
please use the memory modules
of the same type and speed.
2. Align the DIMM module key
with the receptive point on the
single-latch DIMM slot.
3. Push the release tab outwards to
unlock the slot.
4. Align the notch on the end of the
module against the receptive point
on the end of the slot.
5. Press both ends of the module
straight down into the slot until the
module snaps into place.
6. Push the release tab to the lock
position to secure the module into
the slot.
Removing Memory Modules
Reverse the steps above to remove the
DIMM modules from the motherboard.
JPME2:
1-2:NORMAL
2-3:ME MANUFACTURING MODE
JL1:
CHASSIS
INTRUSION
B1
JBT1
JCMOS
LED1
JSTBY1
I-SATA4
I-SATA2
I-SATA0
I-SATA5
I-SATA3
I-SATA1
Receptive Point
Release Tab
2-9
Chapter 2: Installation
DVI
USB 4/5
HDMI/DP
HD AUDIO
(3.0)
LAN
USB 6/7(3.0)
JI2C1/JI2C2
JPUSB1:USB0/1 WAKE UP
ON :ENABLE
1-2 ENABLE
OFF:DISABLE
2-3 DISABLE
MH12
2280
MH11
2260
MH10
2242
BIOS LICENSE
PCIE M.2
CONNECTOR 1
DIMMA1
DIMMA2
JSTBY1:
5V STBY POWER
DIMMB1
DIMMB2
JPW1
SYS_FAN1
Module Key
Notch
Press both notches
straight down into
the memory slot.
KB/MOUSE
USB 0/1
JVR1
Advertisement
Table of Contents
