Connector Description - Supero A1SAi-2550F User Manual

Jumper
JBT1 CMOS Clear
JI C1/JI C2 SMB to PCI-Exp. Slots
2 2
JPG1 VGA Enable
JPL1 Ethernet LAN Ports Enable
JWD1 Watch Dog Enable
Connector
Battery
COM1/COM2
FAN1-FAN3
J1*
J3
JD1
JF1
JIPMB1
JL1
JOH1
JPI C1
2
JPK1
JPW1*
JSD1
JTPM1
JUID1
LAN1/LAN3, LAN2/LAN4 Gigabit Ethernet (RJ45) Ports
PCI-E Slot
I-SATA0-I-SATA5
SP1
USB 2.0 0/1
USB 3.0 0/1
USB 3.0 2/3
VGA
(*Do not use the 4-pin DC power at J1 when the 24-pin ATX Power at JPW1 is connected to the power supply. Do
not plug in both J1 and JPW1 at the same time.)
Jumpers
Description
Headers/Connectors
Onboard Battery (JBAT1)
COM1/COM2 Port Headers
CPU/System Cooling Fans
4-pin 12V DC Power Connector (to provide alternative power to embedded
devices such as SC101i, when the 24-pin ATX power is not in use)
4-pin Power Connector for HDD use (to provide power from the motherboard
to onboard HDD devices)
Power LED/Speaker Header(Pins 1-3: Power LED, Pins 6-7: Internal
Buzzer, Pins 4-7: External Speaker)
Front Panel Control Header
4-pin External SMbus I
Chassis Intrusion Header
Overheat LED Header
Power Supply System Management Bus (SMBus) I
LAN3/LAN4 LED Indication Header
24-pin ATX Power Connector
SATA DOM (Device_On_Module) Power Connector
Trusted Platform Module (TPM)/Port 80 Connector
Unit Identifier (UID) Switch
PCI-E 2.0 x 8 Slot
Intel Serial ATA Ports 0-5 (Ports 4/5 not available on the A1SRi-2358F)
Internal Speaker/Buzzer
USB 2.0 Ports on the Rear I/O Panel
USB 3.0 Ports on the Rear I/O Panel
One USB 3.0 Port via Header + One USB 3.0 Port via Type-A
Backpanel VGA Port
1-5
Description
C Header (for an IPMI Card)
2
Chapter 1: Introduction
Default
Off (Normal)
Off (Disabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Reset)
C Header
2