Watch Dog Timer Enable
Watch Dog (JWD1) is a system monitor that
can be used to reboot the system when a soft-
ware application hangs. Close pins 1-2 to re-
set the system if an application hangs. Close
pins 2-3 to generate a non-maskable interrupt
signal for the application that hangs. See the
table on the right for jumper settings. Watch
Dog must also be enabled in the BIOS.
VGA Enable
Jumper JPG1 allows the user to enable the
onboard VGA connector. The default setting
is pins 1-2 to enable the connection. See the
table on the right for jumper settings.
JUIDB1
VGA
B
BMC
JI2C1
A1SAi/A1SRi Series Motherboard
Rev. 1.00
JI2C2
A
Battery
JWD1
JF1
1
J3
SP1
USB2.0-0/1
USB3.0-0/1
IPMI_LAN
LAN1/LAN3
LAN2/LAN4
Marvell
PHY
BIOS
JBT1
CPU
Jumper Setting
Pins 1-2
Pins 2-3
Open
Jumper Setting
Pins 1-2
Pins 2-3
A. Watch Dog Enable
B. VGA Enable
COM1
FAN3
FAN1
2-27
Chapter 2: Installation
Watch Dog
Jumper Settings
Definition
Reset (default)
NMI
Disabled
VGA Enable
Jumper Settings
Definition
Enabled (Default)
Disabled