Table of Contents
Advertisement
Driver information system
~_--®
m
Tips
Even though your vehicle is equipped with
a speed warning system, you should still
watch the speedometer to make sure you
are not driving faster than the speed limit.
Setting speed warning 1
c:>
page 32.
Speed warning 2
Storing warning 2 is recommended if you a/-
ways want to be reminded of a certain speed,
for example when you are traveling in a coun-
try that has a general maximum speed limit,
or if you do not want to exceed a specified
speed for winter tires.
The speed warning 2 symbol,
[il
(USA mod-
els)/
[il
(Canada models) appears in the dis-
play when you exceed the stored speed limit.
Unlike warning 1, it will not go out until the
vehicle speed drops below the stored speed
limit.
Setting speed warning 2 c:>page 32.
about 3 mph (3 km/hl. At the sa me time, a
warning symbol appears in the display.
The speed warning system has two warning
thresholds that function independently of
each other and that have somewhat d ifferent
purposes:
Speed warning 1
You can use speed warning 1 to set the maxi-
mum speed while you are driving. This setting
will remain in effect until you turn off the igni-
tion, assuming that you have not changed or
reset the setting.
. The speed warning symbol
[i
(USA models)/
ri
(Canada models) in the warning 1 display
appears when you exceed the maximum
·speed. It goes out when the speed falls below
the stored maximum speed.
The speed warning symbol will also go out if
the speed exceeds the stored maximum speed
by more than about 25 mph (40 km/hl for at
least 10 seconds. The stored maximum speed
is deleted.
Overview
Speed warning system
Fig. 23 Display: lap time evaluation
~
To evaluate lap times, press and hold the
1
RE5ETI
c:>
page 30, fig. 21
®
button for ap-
proximately 2 seconds. The display shows
the fastest lap
"+",
the slowest lap "-" and
the average lap time "0".
~
To continue timing for additionallaps, press
the wiper switch @.
~
To reset the timer to zero, press and hold
the
IRE5ETI
button again for approximately
2 seconds.
~
To switch the lap timer off completely,
press the
1
RE5ETI
button briefly.
«D
Tips
- Saved lap times cannot be individually
deleted from the total results.
- The saved lap timer values will not be
lost after turning the ignition off.
Evaluating times and continuing or
resetting timing
Applies to vehicles: with lap timer
You can eva/uate the fastes t, s/owest and
average /ap times.
If timing is paused, you can continue i,t later
even if you switch the ignition off.
The speed warning system warns the driver if
he exceeds a previously stored maximum
speed. A warning tone will sound as soon as
the vehide speed exceeds the set speed by
The speed warning system helps you to keep
your driving speed below a set speed limit.
Fig. 21 Controls
Calling up the lap timer and timing
1
Fig. 22 Display: Lap timer
Applies to vehicles: with lap timer
Calling up the lap timer
~
Press the
1
RE5ETI
c:>
fig. 21
®
button until
the lap timer C:>fig. 22 appears.
Timing laps
~
To start timing, press the upper section of
the wiper switch @. The time measurement
is shown in line
<D
c:>
fig. 22.
~
To stop timing, press he upper section of
the wiper switch @ agaif\. This also starts
timing the next round. The previous time
moves one line up, first to line
(3)
and then
to line@. Une@ shows the current lap
number, for example LAP 5.
Displaying intermediate time and pausing
timing
~
To display an intermediate time, press the
lower section of the wiper switch @. The in-
termediate time appears in line
<D
and is
marked with *.
~
To pause timing, press the lower section of
the wiper switch@ again.
~
To continue timing, press the upper section
of the wiper switch @.
~
@
Tips
When the lap timer stopwatch is running,
you can call up the trip computer informa-
tion with the
1
RE5ETI
button.
Lap timer
Introduction
Applies to vehicles: with lap timer
.&.
WARNING
---
Please dèvote your full attention to driv-
ing. As the driver, you have complete re-
sponsibility for safety in traffie. Only use
the functions in such a way that you always
maintain complete control over your vehi-
de in all traffic situations.
Engine oil temperature indicator
Ifthe engine oil temperature is below 140
oF
(60
oC),
the
'I::;r.
symbol followed by three hy-
phens "- - -" and the
oc
unit is shown.
The engine has reached its operating temper-
ature when the engine oil temperature is be-
tween 176
oF
(80
oC)
and 248
oF
(120
oC)
un-
der normal driving conditions. The engine oil
temperature may be higher ifthere is heavy
engine load and high temperatures outside.
This is not a cause for concern as long as the
•
-:> page 16 or
Il
c:>
page 20 warning light
in the display does not flash.
You can record and evaluate lap times with
the lap timer in the display
c:>
page 30,
fig. 22. The time is measured in minutes, sec-
onds and 1/10 seconds. The hours are also
shown when the lap time exceeds 60 minutes.
The maximum individual measurement is 99
hours.
Il
Hide quick links:
Advertisement
Table of Contents
