Check The Bat Led - AB Quality 1756-ENBT ControlLogix Installation Instructions Manual

Ethernet/ip bridge module

Table of Contents

26 ControlLogix® Controller and Memory Board

Check the BAT LED

1. Turn on the chassis power.

BAT LED

2. Is the BAT LED off?

If:

Yes

3. Check that the battery or battery module is correctly

connected to the controller.

4. If the BAT LED remains on, install another battery.

5. If the BAT LED remains on after you complete step 4, contact

your Rockwell Automation representative or local distributor.

Publication

1756-IN101J-EN-P - November 2004

Then:

Go to "Determine Which Firmware Revisions to Use" on page 10.

Go to step 3.

42525

Table of Contents

Table of Contents