Remove The Removable Terminal Block From The Module - AB Quality 1756-ENBT ControlLogix Installation Instructions Manual

Ethernet/ip bridge module

Table of Contents

18 ControlLogix™ Voltage/Current Input Module

Remove the Removable Terminal Block from the Module

If you need to remove the module, you must remove the RTB first.

When you insert or remove the module while backplane

WARNING

power is on, an electrical arc can occur. This could cause

an explosion in hazardous location installations. Be sure

that power is removed or the area is nonhazardous

before proceeding.

Before removing the module, you must remove the RTB.

1. Unlock the locking tab at

the top of the module.

Remove the Module

1. Push in top and bottom locking tabs.

Publication

1756-IN039D-EN-P - February 2003

2. Open the RTB door and pull

the RTB off the module.

42517

2. Pull module out of the chassis.

20856–M

20855–M

20857–M

Table of Contents

Table of Contents