Table of Contents
Advertisement
Check the Indicators
The indicators show CAL status (green) and a bi-colored LED for
module "OK" (red/green).
During power up, an indicator test is done and the following occurs:
· The "OK" indicator turns red for 1 second and then turns to
flashing green if it has passed the self-test.
LED
This
indicators:
display:
OK
Steady green
light
OK
Flashing
green light
OK
Flashing red
light
OK
Steady red
light
CAL
Flashing
green light
This completes installation of the module. Use the following
information to remove the module, if necessary.
ControlLogix™ Voltage/Current Input Module 17
ANALOG INPUT
CAL
OK
Means:
The inputs are being multicast
and in normal operating state.
1. The module has passed
internal diagnostics but is
not actively controlled.
2 . The controller is in Program
mode.
Previously established
communication has timed out.
The module must be replaced. Replace the module.
The module is in calibration
mode.
Publication
20962-M
Take this action:
None
1. Configure the module
with RSLogix 5000.
2. If ready, switch the
controller to Run mode.
Check controller and chassis
communication
None
1756-IN039D-EN-P - February 2003
Advertisement
Chapters
Table of Contents
