Wire The Ethernet Connector - AB Quality 1756-ENBT ControlLogix Installation Instructions Manual

Wire the Ethernet Connector

Use an RJ45 connector to connect to the EtherNet/IP network. Wire the
connector according to the following illustration:
8 ------ NC
7 ------ NC
6 ------ RD-
5 ------ NC
4 ------ NC
3 ------ RD+
2 ------ TD-
1 ------ TD+
For detailed EtherNet/IP connection information, see the EtherNet/IP
Media Planning and Installation Guide, publication number ENET-IN001.
Connect the Module to the EtherNet/IP Network
WARNING
ControlLogix EtherNet/IP Bridge Module 13
RJ 45
If you connect or disconnect the Ethernet cable
with power applied to this module or any device
on the network, an electrical arc can occur. This
could cause an explosion in hazardous location
installations. Be sure that power is removed or the
area is nonhazardous before proceeding.
Publication
8
1
1756-IN019C-EN-P - November 2004