Install The Module - AB Quality 1756-ENBT ControlLogix Installation Instructions Manual

Install the Module

You can install or remove the module while chassis power is applied.
When you insert or remove the module while backplane
WARNING
power is on, an electrical arc can occur. This could cause
!
an explosion in hazardous location installations. Be sure
that power is removed or the area is nonhazardous
before proceeding.
1. Align the circuit board with the top and bottom chassis guides.
2. Slide the module into the chassis until the module locking tabs
click.
ControlLogix™ Voltage/Current Input Module 7
Printed
Circuit
Board
20861–M
Locking tab
20862–M
Publication
1756-IN039D-EN-P - February 2003