Setting Date And Time; Deleting A Zone - Bosch AMAX panel 2100 Quick Installation Manual

AMAX panel
Menu Items
7 RF
Figure 5.10: RF Manager
Menu Items
8 ADDR./KEY PROGR.
Figure 5.11: Address and Key Programming
5.4.2

Setting date and time

After the system is powered up, date and time must be set. Otherwise, the system displays a
fault.
1.
2.
3.
P
5.4.3

Deleting a Zone

The zones 1-8 are enabled by default. The zone type for zone 1 is set as 03-delay 1, for zones
2-8 as 01-instant by default. Perform the following steps if you want to delete a zone.
1.
2.
3.
4.
5.
Bosch Sicherheitssysteme GmbH
MANAGER
RF SETTINGS
RF RECEIVER
RF SUPERVISION
RF JAM DETECT LEV.
RF LOW BATT REPEAT
SIREN BEEP ARM/DIS
RF KEYFOB PANIC AL
RF ZN MISSING = AL
RF DEVICES / USER
RF REPEATER
REPEATER No: 1-8
REPEATER ID: AUTO
REPEATERID: MANUAL
RF SENSOR DIAGNOSE
RF ZONE No:
RF REPEATER DIAGN.
REPEATER No: 1-8
CLR ALL RF DEVICES
ADDRESS PROGRAM
COPY DATA TO PANEL
COPY DATA TO KEY
Make sure that the system is in a disarmed status (the STAY and AWAY indicators are
disabled).
Enter the installer code [1234] + [51] and press [*] to get to CHANGE DATE / TIME.
Enter the current date and time by using the numeric keys and press [–] to save the data
end exit the programming mode
Date and time are set.
Enter the installer code [1234] + [958] and press [#].
Select 3 ZONE MANAGER and press [#].
Select ADD/DELETE ZONES and press [#].
The system displays the next menu item: INPUT ZONE No.
Enter the number of the zone you want to delete (example: 1) and press [#].
The system displays the next menu item: ZONE MODULE SEL.
Select the correct zone module (default is 0-on board zone) and press [#].
The system displays the next menu item: ZONE FUNCTION.
Programming and operating the AMAX panel | en
Parameters / Description
0-disable 1-enable
0-disable
1-20min
2-1h
3-2,5h
4-4h
5-12h
6-24h
00 - 15 00 = disable, 01 = most sensitive
0-disabled
1-4h
2-24h
0-disable 1-enable
0-no alarm
1-silent alarm
2-audible alarm
0-disable 1-enable
press* 3s for AUTO. 9 Digits
press* 3s for MANUAL. Trigger device, RFID will be entered
CLEAR CONFIRM
CLEAR CANCEL
Parameters / Description
For Addresses, refer to Installation Guide
copy data from blue programming key to Panel
copy data from Panel to blue programming key
Quick Installation Guide
21
Certification Default
0
EN=1 4
12
2
1
2
EN=0 1
Certification Default
2016.05 | 06 | F.01U.309.297