Setting The Date And Time - Bosch CCS 800 Ultro Installation And Operating Manual

CCS 800 Ultro | Installation and Operating Manual
7.3.2 Deleting files
Use this option to delete files.
1 Press the up or down button to select the file to
delete. The filename will change on the display as
the button is pressed.
2 Press the confirm delete button to confirm the file to
delete (the following screen will be displayed).
Figure 7.4: Confirm delete screen
3 On this screen, you can either:
- select the delete file button to permanently delete
a file.
- select the cancel delete button to cancel the delete
file command.
Note
After deleting a file, the software jumps back to
the delete file screen.
4 Press the select button to select the next value to
change (see following section).
Bosch Security Systems B.V. | 2007-08

7.3.3 Setting the date and time

Note
To change settings in the set-up mode, you must
follow the programmed sequence of events
(there is no back button). To exit the set-up mode
at any time, press the change mode button
(button 1 at the left-side of the display).
Before using the MP3 recorder you should make sure
that the date and time are correctly set. If necessary,
adjust the date and time as follows:
1 Press the change mode button (1) to select the set-up
mode. When selected, the set-up icon should be
shown in the top right-hand corner of the display
(see following figure).
Figure 7.3: Set-up screen for date
2 Press the up or down button (4 or 5) to change the
value (year number), and then press the select button
(2) to select the next value to change.
3 Set the date (year, month, and day) as described in
the previous step, and then press the next button (3)
to jump to the time set-up screen.
4 Set the time (hours, minutes, and seconds), using the
same method as described in step 2, and then press
the next button to jump to the bit rate set-up screen
(see following section).
en | 20