Pairing Bluetooth Devices; General; Procedure - FLIR E95 User Manual

21

Pairing Bluetooth devices

21.1 General

You can use the camera with the following Bluetooth devices:
• METERLiNK devices (FLIR meters).
• Bluetooth-enabled headsets.
Before you can use a Bluetooth device with the camera, you need to pair the devices. The
Bluetooth functionality is managed from the Settings menu. You can also enable/disable
Bluetooth on the swipe-down menu. For more information, see section 8.4 Swipe-down
menu, page 23.

21.2 Procedure

Follow this procedure:
1. Push the navigation pad to display the menu system.
2. Select (Settings) and push the navigation pad. This displays the Settings menu.
3. Use the navigation pad to select Connections > Bluetooth.
4. If the Bluetooth check box is unchecked, push the navigation pad to enable Bluetooth.
Note You also need to ensure that the external Bluetooth device is in visible mode.
5. Select Available devices and push the navigation pad.
6. Wait until a list of available devices is displayed. This will take about 15 seconds.
7. When a Bluetooth device is found, select the device to add it, and begin the pairing
procedure. The device is then ready to be used.
Note
• Only METERLiNK devices (FLIR meters) and Bluetooth-enabled headsets will appear
in the list of available devices.
• You can add several devices.
• You can remove a device by selecting the device and then selecting Unpair device.
• After adding a METERLiNK device, such as the FLIR MR77 or FLIR DM93, the result
from the meter will be visible in the result table and stored with the images. For more in-
formation, see section 23 Fetching data from external FLIR meters, page 96.
• After adding a Bluetooth-enabled headset, it is ready to be used for adding voice anno-
tations. Adding a Bluetooth-enabled headset automatically disables the built-in micro-
phone and speaker.
#T810190; r. AI/41890/41890; en-US
94