Software Requirements; Configuration Examples - Siemens ET 200SP Operating Instructions Manual

Application and functions

1.9 Configuration examples

● CPU 1512SP F-1 PN
Article number: 6ES7512-1SK01-0AB0
Further parts and modules that are also required to set up the ET 200SP station, such as
rails, I/O modules or cabling are not listed here. See also /2/ (Page 119) for information on
this.
Components of the communications partner
Components required by the communications partners of the CP 1542SP-1 IRC are not
listed here. You will find references to other products (e.g. TCSB) in the list of references in
the appendix of the manual.
1.8.2

Software requirements

Configuration software
To configure the CP, the following configuration tool is required:
● STEP 7 Professional as of version 14.
Software for online functions
To use the online functions, the following software is required:
● STEP 7 in the version specified above
CPU firmware
To use the CP, a CPU 151xSP with a firmware version ≥ V2.0 is required.
Telecontrol protocols (CP 1542SP-1 IRC)
You will find telecontrol protocols supported by the CP in the section Telecontrol
communication of the CP 1542SP-1 IRC (Page 13).
1.9 Configuration examples
Below you will find configuration examples for the use of the three CP variants.
CP 1542SP-1 - Network separation
The CP is used in the ET 200SP to operate lower-level networks separately or to achieve
separation from the higher-level network.
The ET 200SP can be expanded flexibly with further Ethernet interfaces via the CP. The
network separation allows the setting up of identical machines with the same IP address.
The CP takes over the communication and relieves the CPU.
20
CP 1542SP-1, CP 1542SP-1 IRC, CP 1543SP-1
Operating Instructions, 01/2017, C79000-G8976-C426-03