Siemens ET 200SP Operating Instructions Manual page 4

Preface
Directly below, you will find the firmware version of the CP as it shipped.
The MAV address is printed on the front at the bottom left, above the connectors for the
power supply.
Product names, terms and abbreviations/acronyms
Below you will find terms and abbreviations/acronyms used often in this manual.
● CP
When the property being described is valid in the current context for all three CP types or
if the CP type being used is clear from the context, the abbreviation "CP" will be used
instead of the three following product designations
– CP 1542SP-1
– CP 1542SP-1 IRC
– CP 1543SP-1
If information applies only to a certain product variant. the full module name is specified.
● TCSB
Control center software "TeleControl Server Basic"
● Telecontrol server
PC with installed software "TeleControl Server Basic"
Purpose of the manual
This manual describes the properties of this module and supports you when installing and
commissioning it.
The required configuration steps are described as an overview and there are explanations of
the relationship between firmware functions and configuration.
You will also find information about the diagnostics options of the device.
Required experience
To install, commission and operate the CP, you require experience in the following areas:
● Automation engineering
● Setting up the SIMATIC ET 200SP
● SIMATIC STEP 7 Professional
New in this issue
Editorial revision (MSIP approval)
Replaced edition
Release 11/2016
4
CP 1542SP-1, CP 1542SP-1 IRC, CP 1543SP-1
Operating Instructions, 01/2017, C79000-G8976-C426-03