Partner Stations; Partner Configuration - Siemens ET 200SP Operating Instructions Manual

Configuration and operation
4.5 Telecontrol communication (CP 1542SP-1 IRC)
Port [X1 Px]
If you do not want to use both ports of the bus adapter, you can disable one of the two ports.
You will find information on the other parameters in the information system of STEP 7.
4.5.5

Partner stations

4.5.5.1

Partner configuration

The STEP 7 configuration of the communications partners of the CP (telecontrol server,
DNP3 or IEC master) and the connections to the partners is not possible and not necessary.
Address information of the communications partners
For the communications partners of the CP, the following information is required during the
configuration of the CP:
● TeleControl Basic
– Partner IP address
– Partner port (port number of the listener port of TCSB)
● DNP3 / IEC
– Master station address
– Partner IP address
– Partner port
"Partner stations" (only with DNP3 / IEC)
● Listener port
CP's own listener port
"Telecontrol server" / "Partner"
● Activate partner
Enable the option to be able to use the partners configured later for the communication.
In "TeleControl Basic" the telecontrol server is always enabled as a partner.
52
See section Auto-Hotspot for information on this.
Station address specified on the master
With the IEC protocol the Master station address is not evaluated.
IP address of the master
For the addressing of redundant partners, see section Addressing of single and
redundant communications partners (Page 55).
CP 1542SP-1, CP 1542SP-1 IRC, CP 1543SP-1
Operating Instructions, 01/2017, C79000-G8976-C426-03