Siemens ET 200SP Operating Instructions Manual page 112

Approvals
DE-76181 Karlsruhe
Germany
You will find the EC Declaration of Conformity on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/)
> Entry type: "Certificates", certificate type: "EC declaration of conformity"
IECEx
The CP meet the requirements of explosion protection according to IECEx.
IECEx certificate: IECEx DEK 14.0025X
The CP meets the requirements of the following standards:
● IEC 60079-0
Hazardous areas - Part 0: Equipment - General requirements
● EN 60079-15
Explosive atmospheres - Part 15: Equipment protection by type of protection 'n'
You can see the current versions of the standards in the IECEx certificate that you will find
on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/)
The conditions must be met for the safe deployment of the CP according to the section
Notes on use in hazardous areas according to ATEX / IECEx (Page 31).
You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
ATEX
The CP meets the requirements of the EC directive 2014/34/EU "Equipment and Protective
Devices for Use in Potentially Explosive Atmospheres".
Applied standards:
● EN 60079-0
Hazardous areas - Part 0: Equipment - General requirements
● EN 60079-15
Explosive atmospheres - Part 15: Equipment protection by type of protection 'n'
The current versions of the standards can be seen in the EC Declaration of Conformity, see
above.
ATEX approval: II 3 G Ex nA IIC T4 Gc
Test number: KEMA 07ATEX0145 X
The conditions must be met for the safe deployment of the CP according to the section
Notes on use in hazardous areas according to ATEX / IECEx (Page 31).
112
CP 1542SP-1, CP 1542SP-1 IRC, CP 1543SP-1
Operating Instructions, 01/2017, C79000-G8976-C426-03